ERGON MINING & INNOVATION PRIVATE LIMITED

In their own words

ERGON MINING & INNOVATION PRIVATE LIMITED is company incorporated basically for catering to removing the technical barrier of and process of using & executing mining activits. We are the first one to provide customised services specifically with government tie-up and aim of reaching to 2000 CR within a small time span. Techiques which we undertake are as follows: Mining methods Surface techniques can be broadly classified into (1) contour strip mining, (2) area strip mining, (3) open-pit mining, and (4) auger mining. Contour strip mining Contour mining is commonly practiced where a coal seam outcrops in rolling or hilly terrain. Basically, the method consists of removing the overburden above the coal seam and then, starting at the outcrop and proceeding along the hillside, creating a bench around the hill. In the past, the blasted overburden spoil was simply shoved down the hill; currently, soil is either carried down the mountain to fill a chosen valley in horizontal layers or is replaced on the working bench itself in places where coal has been removed. If the break-even stripping ratio remains favourable, further cuts into the hillside will be made. Otherwise, if there are sufficient reserves under the knob of the hill, the coal may be recovered by underground mining or by augering. Area strip mining Area mining, applied where the terrain is flat, commences with a trench or “box cut” made through the overburden to expose a portion of the coal seam. This trench is extended to the limits of the property in the strike direction. After coal removal, a second cut is made parallel to the first one, and the overburden material from this cut is placed in the void of the first cut. The process is repeated in successive parallel cuts until the stripping ratio indicates that continued surface mining is uneconomical. Open-pit mining In open-pit mining of the coal seam, several benches are established in both the overburden strata and the coal seam. The open-pit method is generally practiced where thick coal seams are overlain by thick or thin overburden; it is also used for mining steeply pitching coal seams. In the beginning stages of mining, considerable volumes of overburden materials must be accumulated in large dump areas outside the mine. Auger mining Auger mining is usually associated with contour strip mining. With this method, the coal is removed by drilling auger holes from the last contour cut and extracting it in the same manner that shavings are produced by a carpenter’s bit. Coal recovery rates approach 60 percent with this method. The cutting heads of some augers are as high as 2.5 metres. As each stem works its way into the coal seam, additional auger stems are added, so that hole depths of more than 60 to 100 metres are not uncommon. Problems of subsidence, water pollution, and potential fires are associated with augering.

Written by the company on its public Startup India profile. Not verified by us.

Is this your company?

Everything here comes from public government records. If something is wrong, the authoritative place to correct it is the Startup India portal itself, and we will pick the correction up on the next monthly snapshot. To flag an error on our side, use the report link or write to trust@indianstartupmap.com.

How we built this record Where the data comes from How you may reuse it